I have a unique setup where clients are utilizing a multipoint radio uplink for connectivity. Their addresses are basically secondary addressing on the GigE on the 6524 switch I'm using.
Since the GigE port sees all of the traffic as if it is part of the same Layer2 connection, is there a way to separate the IP addressing on that GigE into individual subinterfaces without using VLAN ID's? I ultimately want to be able to allow each client site connected on the multipoint link to be able to participate in a VRF for that individual client's network.
Crosswork Cloud - Crosswork Traffic Analysis - FAQ
Crosswork Cloud - Crosswork Traffic Analysis is a Cloud-hosted Software as a Service platform that provides Netflow based Traffic Analytics. The Crosswork Traffic Analysis platform Traffic Analysis, Peeri...
Cisco Champion Radio · S8|E9 Innovations to Achieve a Trustworthy Infrastructure
How do you know for certain that a router in your network has not been altered with since you deployed it? Wouldn’t it be great if you can cryptographically challenge your r...
IOS upgrade on asr9xx mandates rommon upgrades sometimes while they can be optional at other times. You may land up in unwanted situation if proper procedure is not followed during upgrades.
This article will include complete details about rommon ...
In some situation NCS560 RP become unresponsive after reload or powercycle.
In many NCS560 deployments are in remote location, deployment might be large and human intervention should be kept at minimum
Engineering team have been working on a str...
In simple terms, 'Route Churn' is defined as the 'rate of change of prefixes'. Different XR versions across 4.x to 7.x have differing behavior & support for the BGP churn handling and some enhancements made from 6.5.3 onwards (listed in appendix) mak...