07-20-2009 08:58 PM
hi,i have a problem about multicast for mpls vpn.
ce1-Pe1-P-Pe2-Ce2.
at the core use ssm .but i don't know how to config P.the configuration of Pe:
ip multicast-routing
ip vrf a
rd 100:1
route-target both 100:1
mdt default 232.0.0.1
ip multicast-routing vrf a
ip pim ssm default
the configuration of P:
ip pim ssm default.
but display of the PE:
sho ip pim vrf a nei
only have the interface connect with CE .
why don't setup PEs ?
07-20-2009 09:00 PM
i want to know how to config the P.thans !
07-20-2009 09:50 PM
P-config:
ip multicast-routing
ip pim ssm default
Interface config:
ip pim sparse-mode (on all relevant P and PE interface)
You might also need to enable 'address-family ipv4 mdt' on P/PE, dependent of HW/SW
A verification: show ip pim neigh on PE should show P-router as neigbour
07-22-2009 07:27 PM
i try to it.it maybe unused.thanks a lot!
07-22-2009 08:03 PM
thank you very much!i have make it well.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: