cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
546
Views
0
Helpful
0
Replies

xconnect issue

Hello,

I have C892FSP-K9. To port 1 and 2 enters the same multicast, then it is tunneled through xconnect and exits by port 9.

The problem is that traffic from port 1 + traffic from port 2 does not equal port 9 - On port 9 it is too low.

This is reflected in the sound quality of the transmitters - it cannot be used.

If I turn off one port, e.g. 1, then traffic from port 2 equals to port 9 and the sound quality is correct.

What is the reason and how can i fix it?

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: