cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Announcements
Choose one of the topics below to view our ISE Resources to help you on your journey with ISE

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

852
Views
0
Helpful
2
Replies
Participant

AAA Group Issue

I have below config on switch (C2960S-UNIVERSALK9-M), Version 15.0(2)SE7,

aaa group server tacacs+ testgroup
 server name test1
 server name test2
 server name test3

tacacs server test1
 address ipv4 192.1.1.1
 key 7 testkey
 timeout 3
 single-connection

Similarly for test 2 and test3

 

Issue is, when the switch boots, it shows below message though all the authentication and autho is working properly.

 

Mar 25 01:19:10 UTC: %AAAA-4-NOSERVER: Warning: Server test1 is not defined.
Mar 25 01:19:10 UTC: %AAAA-4-NOSERVER: Warning: Server test2 is not defined.
Mar 25 01:19:10 UTC: %AAAA-4-NOSERVER: Warning: Server test3 is not defined.

 

Only reason I can think of is when the switch boots, it parses line by line and since the ip addresses of test1,test2,test3 are defined after the declaration, we are receiving this message? Can someone please advise?

 

Thanks 

 

 

 

 

 

 

 

 

Everyone's tags (1)
2 REPLIES 2
Highlighted
Beginner

rakeshvelagala,Try config

Try config with this command:

tacacs-server host x.x.x.x single-connection timeout 3 key 0 yyyyyyyyyy

 

Regards,

GUs Magno

Highlighted
Cisco Employee

This occurs as the "aaa group

This occurs as the "aaa group-server" commands are before the definition of "radius server name" in parser.