cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Announcements
Choose one of the topics below to view our ISE Resources to help you on your journey with ISE

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

2251
Views
0
Helpful
1
Replies
Highlighted
Beginner

AAA TACACS with Brocade Switches

We are testing authentication on Brocade switches with our AAA TACACS+ server.  It seems that after authenicating to enable mode, you can type "exit" and be dropped back to level 7 mode.  From this point you can type "enable" and authenticate to the switch using the local "enable" password, not from TACACS.  Has anyone run across this and is there a way to correct it?  Is there something that needs to be configured in TACACS on the server to recognise the Brocade switch and make this work?

Ray

Everyone's tags (1)
1 REPLY 1
Highlighted

AAA TACACS with Brocade Switches

Hi Ray,

What ACS version you are using?

On a cisco switch the following command is used:

switch(config)# aaa authentication enable default tacacs+ enable

The above command is used to set the TACACS+ as the default check for the enable password. If TACACS+ is not available it will fall back to the local enable password.

You need to look into such option in the Brocade switch.

HTH

Amjad

Rating useful replies is more useful than saying "Thank you"

Rating useful replies is more useful than saying "Thank you"