ACS 4.2 to authenticate VPN Users

[r.grant3779]

Hi All,

Have configured ASA for remote access VPN users using anyconnect. This all works and can authenticate if I use a local account on the ASA. I want to now use my ACS 4.2 server to authenicate VPN users using TACACs. At the moment the server is handling the job of securing our network devices but not sure how to go about setting it up to authenticate VPN users.

Any pointers?

Thanks

[Jatin Katyal]

Cisco recommends to use radius protocol for vpn authentication.

You may go through the below listed links:

http://www.cisco.com/c/en/us/support/docs/security/pix-500-series-security-appliances/82480-pixasa7x-vpn4x-acs-auth.html

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/110119-asa-vpn-acs.html

Let us know if you have any questions.

Regards,

Jatin Katyal

*Do rate helpful posts*

[edelgado]

Hello,

I wont suggest using tacacs as this is use for management and not access control.

Below is an example with PIX. If you need more assistance I will be more than happy to assist you with this task.

http://www.cisco.com/c/en/us/support/docs/security/pix-500-series-security-appliances/82480-pixasa7x-vpn4x-acs-auth.html

Regards,

Erick Delgado