cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Announcements
Choose one of the topics below to view our ISE Resources to help you on your journey with ISE

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

511
Views
0
Helpful
3
Replies
Highlighted
Beginner

ACS 5.2 IP address of user authing

In acs, we are able to see the username and some other info about the user authing, but what I am unable to view is IP address, and mac address. Is it possible to have the wireless controller send over that info in radius and to be able to view it in acs?

Everyone's tags (3)
3 REPLIES 3
Highlighted
Cisco Employee

ACS 5.2 IP address of user authing

Did you check the same information under

Monitoring & Reports > Reports > Catalog > AAA Protocol

While you see a log entry >> click on the magnifying glass to see all the information.

Regards,

Jatin

Do rate helpful posts-

~Jatin Katyal
Highlighted
Beginner

ACS 5.2 IP address of user authing

In the RADIUS Authentication Detail report, MAC/IP Address is blank in the Auth Summary, and the Framed IP is blank under user.

Highlighted
Cisco Employee

ACS 5.2 IP address of user authing

So did you turn on the debugs on the controller to check if controller is sending the same information or not.

You may check this by enabling

debug aaa radius enable

do let me know.

Regards,

Jatin

~Jatin Katyal