02-03-2011 01:49 PM - edited 03-10-2019 05:47 PM
When I add locations under Network Device Groups and then try and use them in my Access Policies they don't show up. It just says "No data to display". If I try and recreate them I get an error "Object you are trying to Create already exists.' but it is blank. I can run an export and they show up in the CSV file but they don't show up anywhere on the GUI. I have deleted the file and recreated with the same result.
I have been searching all over for anyone with a similar situation but have come up empty. Any thougts?
Regards,
Andy
Solved! Go to Solution.
02-04-2011 06:06 AM
I have recollections about two issues related to this:
- If there are mutliple attributes with the same name as the NDG. Eg if create a user attribute called "Locations" it can cause problems. Can be resolved by renaming the attribute
- Could be issues if word "system" appears in NDG node name
Not 100% sure for these (disclaimer) but wanted to mention in case it gives some pointers
02-04-2011 06:06 AM
I have recollections about two issues related to this:
- If there are mutliple attributes with the same name as the NDG. Eg if create a user attribute called "Locations" it can cause problems. Can be resolved by renaming the attribute
- Could be issues if word "system" appears in NDG node name
Not 100% sure for these (disclaimer) but wanted to mention in case it gives some pointers
02-04-2011 11:14 AM
That was it. I had a custom user attribute named "Location". I removed it and the locations showed up in NDG's.
Thank you!
Andy
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: