cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1115
Views
0
Helpful
1
Replies

ACS 5.3 and Brocade SAN Switch Integration Problem

andrew-hunt
Beginner
Beginner

Hello all,

I am trying to use RADIUS authentication for Brocade SAN switches, specifically the HP AJ821A switch for the c-class blade enclosure.

SAN switch configuration is:

aaaconfig --add 10.180.250.222 -conf radius -s sharedsecret -a peap-mschapv2

aaaconfig --authspec "radius;local" -backup

ACS is configured with an Access Service set to PEAP with the inner method as EAP-MS-CHAPv2

Authentication works fine if set to PAP (so I know it's hitting the right service and so forth) but when it is set to PEAP I get the following error:

11818 Failed to parse EAP-MSCHAP packet

Any suggestions?  Anyone else run into this problem?  Anyone managed to get it working?

Thanks,

Andrew.

1 Reply 1

Dmitry Kishkin
Beginner
Beginner

Hi all. I have this problem too. May be anyone can help me ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: