This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC!
We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.
Hi all!
I got a primary and secondary acs. I added new aaa network devices but they aren't replicated to the secondary acs.
Replication status says pending.
I wanted to do a manual replication with command:
"replication force-sync"
but it's not available.
Can you tell me how to get into the acs-config prompt?
Thank you.
Solved! Go to Solution.
acs/admin# acs-config
acs/admin(config-acs)# replication force-sync
Only the super admin or system admin can run this command on a secondary ACS node.
You can use this command only on a secondary ACS.
ACS restarts after the primary-to-secondary synchronization is complete.
acs/admin# acs-config
acs/admin(config-acs)# replication force-sync
Only the super admin or system admin can run this command on a secondary ACS node.
You can use this command only on a secondary ACS.
ACS restarts after the primary-to-secondary synchronization is complete.