08-25-2020 10:52 PM
Hi all!
I got a primary and secondary acs. I added new aaa network devices but they aren't replicated to the secondary acs.
Replication status says pending.
I wanted to do a manual replication with command:
"replication force-sync"
but it's not available.
Can you tell me how to get into the acs-config prompt?
Thank you.
Solved! Go to Solution.
08-26-2020 12:43 AM - edited 08-26-2020 12:46 AM
acs/admin# acs-config
acs/admin(config-acs)# replication force-sync
Only the super admin or system admin can run this command on a secondary ACS node.
You can use this command only on a secondary ACS.
ACS restarts after the primary-to-secondary synchronization is complete.
08-26-2020 12:43 AM - edited 08-26-2020 12:46 AM
acs/admin# acs-config
acs/admin(config-acs)# replication force-sync
Only the super admin or system admin can run this command on a secondary ACS node.
You can use this command only on a secondary ACS.
ACS restarts after the primary-to-secondary synchronization is complete.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide