03-30-2013 05:54 AM - edited 03-10-2019 08:15 PM
Hi, i have cisco ACS 5.2 and want to create user account for technician, with only certain commands.
how can i achieve this ?
thanks
Solved! Go to Solution.
03-30-2013 10:20 AM
Hi,
That is possible of course.
This document (part of it) shows command authorization on acs 5.x
http://www.cisco.com/en/US/products/ps9911/products_configuration_example09186a0080bc8514.shtml#ade
HTH
Amjad
Sent from Cisco Technical Support iPad App
03-30-2013 06:34 AM
Hi,
You can not do per-commadn authorization.
But You can assign some of the pre-defined roles to the admin.
check this:
Reards,
Amjad
Rating useful replies is more useful than saying "Thank you"
03-30-2013 08:25 AM
Hi Amjad,
I am looking for giving technician some commands, like configure IP address inside interface and enable it. I dont want him to login to ACS, i want him to login in to devices authenticated through acs and once he logged in he can only access the given commands.
I am not aware how to do it ?
thanks
03-30-2013 10:20 AM
Hi,
That is possible of course.
This document (part of it) shows command authorization on acs 5.x
http://www.cisco.com/en/US/products/ps9911/products_configuration_example09186a0080bc8514.shtml#ade
HTH
Amjad
Sent from Cisco Technical Support iPad App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide