ACS3.2 and evaluation attribute 31 (Calling Station ID)

[kfischbach]

Hi,

we are using Wireless with LEAP and what we want is, that attribute 31

is evaluate by the ACS during RADIUS ACCESS Request.

The Problem is, that I couldn’t find the attribute 31 in the ACS

Radius IETF Part.

Regards

Karlheinz

[yusuff]

Accounting Attribute 31 is enabled by default on ACS. If you go to ACS; click System Configuration--> Logging --> CSV RADIUS Accounting, you will find the Calling-Station-Id.

But note that this attibute is only available supported on ISDN calls and modem calls on AS5xxx is used with PRI. See Table B-3 in URL below;

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacs4nt/csnt2/ap_rads.htm

R/Yusuf