07-08-2011 10:08 AM - edited 03-10-2019 06:12 PM
Hi,
I want to set it up so that when you log into any of the ACS 5.2 servers you have to use your AD credentials to log in and define what access you have. Is this possible? If so, how can this be set up?
Thanks,
Randy
07-12-2011 05:28 AM
Nope, not that I have found. I'm not sure if they are going to do this in a future release or not, but it sure would be nice.
01-19-2018 03:12 AM
Hi
Is there an official statement from Cisco stating this.
Ive been asked to do the same apart of our security best practices.
01-19-2018 10:43 AM
07-13-2018 04:19 AM
This now works in 5.8, I "think" the feature was added in 5.4 but I'm not 100% on that.
07-13-2018 05:01 AM
Works for our 5.6 ACS servers as well. Check if the following exists:
System Administration > Administrators > Administrative Access Control
> Identity
> Authorization
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide