cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1087
Views
5
Helpful
2
Replies

Catalyst WS-C2960G-48TC-L and dot1x

hello, i have a WS-C2960G-48TC-L switch with (C2960-LANBASEK9-M), Version 12.2(53)SE2 IOS. I need to configure on his interfaces dot1x, but is not active all de options on the interface dot1x submenu:

C2960G(config-if)#dot1x ?
  credentials     Credentials profile configuration
  default         Configure Dot1x with default values for this port
  max-reauth-req  Max No.of Reauthentication Attempts
  max-req         Max No.of Retries
  max-start       Max No. of EAPOL-Start requests
  pae             Set 802.1x interface pae type
  supplicant      Configure supplicant parameters
  timeout         Various Timeouts

i can't find the :  port-control,  mac-auth-bypass

tell me please what is the problem

2 Replies 2

Tiago Antunes
Cisco Employee
Cisco Employee

Hi,

Please note that the dot1x commands have changed in version 12.2(50) and later.

Here you can find the new commands:

http://www.ciscosystems.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_53_se/configuration/guide/sw8021x.html#wpmkr1468843.

HTH,
Tiago

--

If  this helps you and/or answers your question please mark the question as  "answered" and/or rate it, so other users can easily find it.

thanks, new version of command is authentication port-control