cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2395
Views
0
Helpful
2
Replies

Cisco ISE 2.7 - AUP in Policy Conditions

FatumFL
Level 1
Level 1

Good day! Can you please tell me how information about AUP is stored for guest users? Is there a way to use AUP (accepted / not accepted) results in authorization policies? The task is to show the custom portal with only an AUP page to guest users registered by the Sponsor / on the Sponsor Portal when they connect to the network for the first time.

2 Replies 2

Panos Bouras
Level 1
Level 1

Hi @FatumFL,

 

AUP is within your portal and you can access it by going into portal edit (create a copy for tessting first and use preview to check your settings).

You can edit your portal to have as mandatory AUP acceptance by the users.

Thank you,Panos.
Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies

Enable AUP requirement here:

image.png

 

Acceptance of the AUP is implicit in the Guest_Flow condition that is built-in to ISE. This is part of the default Authorization Rule Wi-Fi_Guest_Access if you enable it.

image.png

 

You can verify AUP Acceptance using the report Operations > Reports > Reports > Guest > AUP Acceptance Status

image.png

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: