cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

13550
Views
25
Helpful
8
Replies
Ricky S
Participant

Cisco ISE factory reset

Good morning,  is there a way to reset the ISE appliance 3595 back where it asks to type "setup" to begin configuration?

1 ACCEPTED SOLUTION

Accepted Solutions
Timothy Abbott
Cisco Employee

To do that, you will have to re-image the server.  If you want to reset ISE back to factory defaults with out having to go through the process of assigning an IP address, FQDN, domain, etc.  you can use the below:

 

application reset-config ise

 

Regards,

-Tim

View solution in original post

8 REPLIES 8
Timothy Abbott
Cisco Employee

To do that, you will have to re-image the server.  If you want to reset ISE back to factory defaults with out having to go through the process of assigning an IP address, FQDN, domain, etc.  you can use the below:

 

application reset-config ise

 

Regards,

-Tim

How do you re-image the server?

How do you re-image the server?

once you apply the command

 

 application reset-config ise

 

it will ask you if you want to retain your existing certificates. either yes or no. it will reset your box/applicance to a new fresh install. however, it will keep the existing config forexample the ip address of the ise interface and the ip-default gateway.

 

 

 

 

please do not forget to rate.

Does this clear the license?

Yup.

Hello Team,

 

what if i want to remove ip address as well.

 

Also does factory reset removes ISE Image ??

cmhc
Beginner

Ok I ran into problem where I forgot to deregister the node before moving the node to a diffrent DC. If you want to re ip the node what you need to do id deregidter the node from Primary eventhough the node is not reachable. do application reset which wil say prime db fail but ok . that will allow you to change ip of the interface. Make sure you retain certificates. After the interfaces are configured and reachable. do reset again.which will make the node clear. after that join the node to deployment.

Create
Recognize Your Peers
Content for Community-Ad

ISE Webinars


Miss a previous ISE webinar?
Never miss one again!

CiscoISE on YouTube