Hello team, I purchased two Cisco SNS-3615 for my end customer and in the BOM I have this option "SW-36X5-ISE-K9(Cisco ISE Software Load on SNS-36x5-K9 appliance) and want to confirm if the software is already loaded on the appliance or I have to download on software website for deployment?
Please waiting for your feedback.
Solved! Go to Solution.
In my knowledge all Cisco SNS-36X5-K9 comes with ISE already installed on it all you need is to apply the initial config to help you have control of device and deploy your solution as needed. You'll need below informations for initial setup
- IP Address
- DNS information
- NTP information
- Admins credentials.
But if you have any doubt you can confirm with your support or reseller.