Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
883
Views
0
Helpful
1
Replies

Combining Default ACLs with Radius assigned ACLs in L2TP

ricart.cortinas
Level 1
Level 1

‎10-13-2010 08:22 AM - edited ‎03-10-2019 05:29 PM

Hi there,

is it possible to assign an ACL defined by Radius and at the same time the LNS combine the use of this ACL with the default ACL defined in the Virtual-Template?

I've checked following instructions on this cisco document but what I can see is that ACL asssigned by Radius deactivates the defeault ACL existing in router config defined in virtual-template... even when defined one as IN and the other in OUT.


Do you know any way to combine usage of both? One for general security control and the other for specific usage limitations...

Labels:
0 Helpful
1 Reply 1

ricart.cortinas
Level 1
Level 1

‎10-13-2010 08:24 AM

Sorry, this was the original document by Cisco I've been cheching: How to Apply Access Lists to Dial Interfaces with a RADIUS Server

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents