04-15-2003 05:46 AM - edited 03-10-2019 07:15 AM
Hi,
All the documents found on your web site about 802.1x say that you globally 3 steps :
1/ Put 802.1x on an interface
2/ Configure the IP address of the radius server
3/ Configure aaa
But on a Catalyst 6500, which is on a Hybrid Mode (Cat OS + Router Mode on MSFC), there is no command for aaa (like "aaa authentication dot1x default group radius" available on IOS) on the Cat OS. Does it mean that we need to be on IOS (native or on MSFC) to configure the ""aaa" part of the 802.1x or does an identical command (with the same sense) exists on Cat OS exists ?
I have an another question about the possibility to affect a Vlan on a port by 802.1X on a 3550. when the ethernet interface is on switching mode, I type "switchport mode access" . But this command affects the interface in the default vlan (1). The radius server is correctly defined with the right options (Vlan, 802 and Vlan Name) and the swith also (Vlan name and number in the Vlan database). However, the interface of the user does not appear in the vlan configured .... Do you have some way to explain this ?
Best Regards
P.S : the versions are the good ones.
04-22-2003 11:03 AM
Hi,
Answer to your first question: I dont think so there is any equivalent command....even I was looking for the same.
Regards,
Roh
04-23-2003 05:47 AM
you will find how to configure aaa in catos mode (so on you 6500) at this adress :
Did you find how to configure vlan assignment on your 3550 ? I try hard, but it does not work, so if you have some advices, it would be helpfull.
Thanx !
04-28-2003 12:44 AM
Hi,
the correct page for 802.1x cat 6500 is:
for IOS I found the following page:
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide