cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
306
Views
0
Helpful
3
Replies

Do we support RADIUS over IPv6 in ACS 5.5?

Srikanth Raghavan
Cisco Employee
Cisco Employee

Hi,

Could you please let me know if we support RADIUS over IPv6?

 

3 Replies 3

nspasov
Cisco Employee
Cisco Employee

It is hard to see the information in your screen shot but ACS 5.4 and later support IPv6 for network devices:

http://www.cisco.com/c/en/us/td/docs/net_mgmt/cisco_secure_access_control_system/5-4/user/guide/acsuserguide/net_resources.html

Also, if you type an invalid IP address in ACS you would get the following error:

A valid IPv4 address consists of four numbers (0-255) separated by periods, e.g. 123.0.255.3
A valid IPv6 address is n:n:n:n:n:n:n:n where the 'n's are either digits (0-9) or letters (A-F)

I hope this is what you were looking for!

 

Thank you for rating helpful posts!

Thanks Neno. I think we do support IPv6 client configuration with TACACS, but not with RADIUS.

I have uploaded a better picture this time. Hope it helps.

 

Ugh sorry I concentrated too much on the screen shot and not on the title of your thread :( Sorry about that. Yes, IPv6 is supported for TACACS+ only. This is both for ACS and ISE.

 

Thank you for rating helpful posts!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers