01-19-2012 10:10 PM - edited 03-10-2019 06:44 PM
Hi guys,
can someone explain the difference between "mab" and "mab eap" to me?
I`m trying to do dot1x with EAP-TLS with MAB as a fallback method.
The explanations I found in the config-guides are very poor.
Thank you for your help.
Mathias
Solved! Go to Solution.
12-09-2012 02:52 PM
Hello Mathias-
This is an old post but I stumbled across it when trying to find another post that I answered before. In case you haven't found an answer yet, please take a look at this thread where I think you will find your answers.
https://supportforums.cisco.com/message/3768500#3768500
Regards,
Thanks for rating!
12-09-2012 02:52 PM
Hello Mathias-
This is an old post but I stumbled across it when trying to find another post that I answered before. In case you haven't found an answer yet, please take a look at this thread where I think you will find your answers.
https://supportforums.cisco.com/message/3768500#3768500
Regards,
Thanks for rating!
12-09-2012 10:05 PM
Thank you for your response. That`s excactly what I was looking for.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: