cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
373
Views
0
Helpful
4
Replies

ISE 1.0.4 backup

rakeshvelagala
Level 3
Level 3

Hi All,

 

I have taken backup on ISE  version 1.0.4 application data. When I am restoring it on 1.1.0, it says as below

 

7 [13168]: backup-restore:history: br_history.c[310] [admin]: added record to history
% The backup file decryption failed. Ensure that you are providing password used at the time of backup.
6 [13168]: backup-restore:restore: br_cli.c[843] [admin]: error message: The backup file decryption failed. Ensure that you are providing password used at the time of backup.

 

But there is no password I have specified when taking backup in 1.0.4. Can anyone please advise if I am missing something?

 

Thanks

 

4 Replies 4

Jatin Katyal
Cisco Employee
Cisco Employee

What command are you using to restore the application backup?

To restore the application data, from the Cisco ISE CLI, enter:

restore backupfilename.tar.gpg repository repositoryname application ise

For more info:

http://www.cisco.com/c/en/us/td/docs/security/ise/1-0-4/user_guide/ise104_user_guide/ise10_backup.html#wp1053926

 

Hope this helps.

Regards,
Jatin Katyal
*Do rate helpful posts*

~Jatin

kaaftab
Level 4
Level 4

make sure the passwrod you provided is the same password which you used as this error is for decrypting key

Naveen Kumar
Level 4
Level 4

please check: We recommend that you do not change the system timezone after the initial ISE installation and setup.

http://www.cisco.com/c/en/us/td/docs/security/ise/1-1/user_guide/ise11_user_guide/ise_backup.html#wp1053926

Venkatesh Attuluri
Cisco Employee
Cisco Employee

you need to enter a encryption key when you create a back up

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: