07-23-2017 06:22 PM
Hi Team
One of my customers is planning to install ISE 2.2 on Hyper-V however is concerned of it’s stability since 2.2 is the first release supported on Hyper-V.
Any feedback on it’s stability with Hyper-V? Any known issues?
- Basant
Solved! Go to Solution.
07-24-2017 10:10 AM
Hi Basyadav,
We have customers using ISE 2.2 in Hyper V. There seem to be no major issues.
Couple of things I noticed was that
1. Allocate the minimum amount of HDD for ISE nodes.
2. There was one issue where out of two nodes 1 ISE node was working and the second ISE node was not after install.
When Hyper V was updated to support Gen 2, things started working in this second node.
In general follow best practices installing latest patches etc
Hope it helps.
Thanks
Krishnan
07-24-2017 10:10 AM
Hi Basyadav,
We have customers using ISE 2.2 in Hyper V. There seem to be no major issues.
Couple of things I noticed was that
1. Allocate the minimum amount of HDD for ISE nodes.
2. There was one issue where out of two nodes 1 ISE node was working and the second ISE node was not after install.
When Hyper V was updated to support Gen 2, things started working in this second node.
In general follow best practices installing latest patches etc
Hope it helps.
Thanks
Krishnan
07-25-2017 06:32 AM
Thanks a lot Krishnan ! Appreicate your help.
- Basant
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: