cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
555
Views
0
Helpful
1
Replies

ISE after power off !!

yhamoudah
Level 1
Level 1

Hi everyone,

I have ISE VMWare based. Every time, when I switch the power of the server off for any reason, and turn it on again, I lose the connectivity through HTTP to the ISE but I can still ping it !!!!

I couldn't know what was the issue and for this, I re-installed the whole image again and the problem was solved but now I am facing the same problem since the server was turned off

Plz Help Me

Regards,

1 Reply 1

tisnow
Cisco Employee
Cisco Employee

What version are you running?

Have you checked the VMware settings against the recommendations for memory/HD/CPU/etc?

Have you checked that the VM is set to bridge mode?

I've been runnint 1.0.4 in my lab for 4 months and have had it shut it down (improperly, due to power interuptions) and I haven't seen this problem.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: