We have a question on the use of SNAT for load balancing - according to the documentation at the following link: https://community.cisco.com/t5/security-documents/ise-load-balancing/ta-p/3648759#toc-hId-1865742776, it appears that the load balancer always needs to go inline (without SNAT).
That article is from 2016 - is the information in that article still correct? Or is there any way we can implement a load balancer using SNAT, without it going inline?
Go to Solution.
The load balancer can't SNAT RADIUS calls from the network device to ISE. As far as I know (and have implemented many times) this requirement hasn't changed.
View solution in original post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: