ISE Any Connect Complaince Module 4.x

[Ali]

ISE Any Connect Complaince Module 4.x

Hello Community,

Currently running with ISE 2.1 Patch 5. Some End-users have Any connect 4.5 with Compliance Module 3.x. so far so good.

In few New PC's we have AnyConnect 4.5 with Compliance Module 4.2 so I have to create New posture policy  with 4.x compliance module.

we have few mandatory conditions that need to match in posture policy.

So my question is when I am creating a new "Antivirus Condition" by default it is taking compliance Module 3.x,  how to change to 4.x Compliance module so that I can call this AV condition in Posture policy.

Helpful suggestion would be highly appreciated.

Thanks

[hslai]

AV/AS conditions are for CM 3.x only. For CM 4.x, use AM (Anti-malware) conditions, instead.

[Ali]

Thank you for your reply.

So if I create antimalware condition policy for Compliance Module(CM) v4 and then I call this is posture policy for CM 4,

what about my existing policy with " compliance module 3 " that will be replaced or will it be there in policy ?

My requirement is to keep both the policy with CM v3 and CM v4

[hslai · Accepted solution]

Posture policy has a column "Compliance Module", which is a drop-down selection of 4.x or later, 3.x or earlier, and Any version. Thus, it depends on how your existing policy is.