cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

556
Views
0
Helpful
4
Replies

ISE Ethernet NICs

Hi,

Can we seperate each NIC into different networks ?

For example,

NIC1: 10.10.10.x

NIC2: 192.168.10.x

I see that we can configure ip default gateway only for 1 address.

Thanks,

Cat

4 REPLIES 4
Karsten Iwen
VIP Mentor

Why do you want to do that? Perhaps there is a better solution for your problem.

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni

I want to test that if the user is on the different IP group then she can access via the same ip pattern. That's it.

Hi,

This is not supported. The other NICs are to be used as a probe, of if you are deploying an inline posture node, then nic 1 and nic 2 are used for the untrusted and trusted interface.

Thanks,

Tarik Admani
*Please rate helpful posts*

There can be up to 4 NICs defined on ISE

In ISE 1.1.1 the management interface can be accessed only on Eth0. However, ISE will listen on all defined NICs for RADIUS requests

I am not sure of the answer to your question on the default gateway and will check this out

Create
Recognize Your Peers
Content for Community-Ad

ISE Webinars


Miss a previous ISE webinar?
Never miss one again!

CiscoISE on YouTube