08-20-2014 08:34 AM - edited 03-10-2019 09:57 PM
I have ISE with latest version 1.2.1.198
I never see any entries in the live authentications page even though I have clients successfully authenticating and being authorised.
Different browsers seem to make no difference.
Has anyone also seen this and has anyone found a bug relating to this?
Regards
Roger
Solved! Go to Solution.
08-22-2014 06:42 AM
make sure your NAD is configured correctly . and try
ms-ise-mgm01/admin# app config ise
Selection ISE configuration option
[1]Reset Active Directory settings to defaults
[2]Display Active Directory settings
[3]Configure Active Directory settings
[4]Restart/Apply Active Directory settings
[5]Clear Active Directory Trusts Cache and restart/apply Active Directory settings
[6]Enable/Disable ERS API
[7]Reset M&T Session Database
[8]Rebuild M&T Unusable Indexes
[9]Purge M&T Operational Data
[10]Reset M&T Database
[11]Refresh M&T Database Statistics
[12]Display Profiler Statistics
[13]Exit
try
7 to reset the session db
10 to reset the M&T database
Once you have run these commands the DashBoard should begin to display information.
08-21-2014 08:55 AM
Silly question but do you have the ISE servers configured as "accounting" servers in your NADs?
Thank you for rating helpful posts!
08-31-2014 12:24 PM
Yes I have the ISE Servers configured as accounting servers.
08-22-2014 06:42 AM
make sure your NAD is configured correctly . and try
ms-ise-mgm01/admin# app config ise
Selection ISE configuration option
[1]Reset Active Directory settings to defaults
[2]Display Active Directory settings
[3]Configure Active Directory settings
[4]Restart/Apply Active Directory settings
[5]Clear Active Directory Trusts Cache and restart/apply Active Directory settings
[6]Enable/Disable ERS API
[7]Reset M&T Session Database
[8]Rebuild M&T Unusable Indexes
[9]Purge M&T Operational Data
[10]Reset M&T Database
[11]Refresh M&T Database Statistics
[12]Display Profiler Statistics
[13]Exit
try
7 to reset the session db
10 to reset the M&T database
Once you have run these commands the DashBoard should begin to display information.
09-01-2014 04:01 AM
This did the trick.
Thanks very much for the pointer.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: