ISE on SP300-24P Switch

[Haydn Andrews]

Hi All,

Been tasked with configuring a Cisco SP300-24P Switch to comply with ISE.

We currently have ISE running on Cat Switches no issues, my question is regarding is ISE supported on the SP300-24P.

I can see that the command aaa new model is not supported, aaa group server not supported.

aaa new model

aaa group server

mac address-table notification change

mac address-table notification mac-move

Port commands not supported

authentication event fail action next-method

authentication event server dead action reinitialize vlan 2

authentication event server dead action authorize voice

authentication event server alive action reinitialize

authentication host-mode multi-auth

authentication open

authentication order dot1x mab

authentication priority dot1x mab

authentication port-control auto

authentication periodic

authentication timer reauthenticate server

authentication violation restrict   dot1x pae authenticator

was wondering if anyone has a sample config for ISE config on this model switch                  

[Naveen Kumar]

I have gone threw the configuration guide of SF 300 series switch and found that this supports 802.1x authentation. So I believe its support ISE also. But you are right aaa new model command is not supported in this. Did you tried without this command?

config guide:

http://www.videosec.com/Cisco-support/SF300-administartion-guide-en.pdf