Didnt reimage SNS appliances for a long time & need community help to refresh my memory please.
when we follow either of "Install Cisco ISE" procedure (e.g. Cisco Identity Services Engine Installation Guide, Release 3.4 - Install Cisco ISE [Cisco Identity Services Engine] - Cisco) Step 3 & boot appliance from KVM mapped vDVD & then get prompted with
[1] Cisco Secure ISE Installation (Keyboard/Monitor)
[2] Cisco Secure ISE Installation (Serial Console)
...
& we select either of 1 or 2 it immediately triggers reimaging & only upon installation of target SW is fully complete we are prompted to proceed with Step 4 of configuring appliance with
**********************************************
Please type 'setup' to configure the appliance
**********************************************
Is my memory still operational?
