ISE: Select allowed protocols/servers sequence in policy set

[cisco_eng_1]

My question: – Is it possible to disable the requirement to select allowed protocols/servers sequence in policy set in version 2.7 and above?

Back in version 2.2 requirement was only condition and allowed protocols were results for authentication.

1. Is it possible to disable it on version 2.7?
2. Is it possible to disable it in any other versions? 3.0 or 3.1 or any plans for this to be available in future releases?
3. Is it possible to request feature improvement if the above is not possible?

[Filip Po · Accepted solution]

Hello, 

of course, if you do not want to restrict any of the protocols, then edit Default Network Access list to allow all checkboxes. This will turn off this requirement. If there is only one list, the choosing right one will be easy.

[thomas]

I don't understand.

Pictures would help to understand exactly What you are trying to disable Where.