cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
188
Views
0
Helpful
2
Replies

ise stuck in configuration memory testing memory

teamdv6199
Level 1
Level 1

we have a cisco ISE 3595 and I rebooted it by typing reload in the cli. I finally hooked up a vga connection to a monitor and its just stuck on "configuration memory testing memory", keyboard seems unresponsive. I tried connecting from the I/O in the front to my laptop but no cli shows up. Any advice? I already manually rebooted it. Its just stuck  There is a IP which I think is for CIMC. 

1 Accepted Solution

Accepted Solutions

balaji.bandi
Hall of Fame
Hall of Fame

Turn off whole appliance removing the power - wait for 5-10min and turn on and check.

what LED it show from of the box ? if that is show still same issue.

May be i were you - i will open a top cover and reseat the RAM and turn and check ?

still issue raise an TAC case for RMA

 

 

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

2 Replies 2

balaji.bandi
Hall of Fame
Hall of Fame

Turn off whole appliance removing the power - wait for 5-10min and turn on and check.

what LED it show from of the box ? if that is show still same issue.

May be i were you - i will open a top cover and reseat the RAM and turn and check ?

still issue raise an TAC case for RMA

 

 

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Hello,

I took out the cmos battery reseat the RAM, plugged in the power cables  and it came back up! WHat is the best practice to reboot the ISE for nexttime?