01-07-2021 03:21 AM - edited 01-07-2021 03:23 AM
Hello,
I need a little help for one problem that i'm having with ISE. So i have implemented a portal for GUEST_ACCESS in ise and configured WLC with radius for ise and ACL.
This WLC as a lot of radius and SSID in production, but i created only one SSID and gave it the radius for ISE.
The problem is im getting everything on ISE in the other SSID's on the radius live logs, even if those SSID don't have ise as radius confdigured. Why is this happening, any ideas?
It should only get the connections for the SSID i created, any help?
01-07-2021 03:37 AM
01-07-2021 04:08 AM - edited 01-07-2021 04:08 AM
But how can the other SSIDs send radius messages to my ISE when i did not configure them with ISE as a radius one?
The only SSID that as ISE as Radius is my TEST_SSID
But ISE is receiving everything from the other ones...all of them =/
01-07-2021 05:19 AM - edited 01-07-2021 05:24 AM
Hi @Kalimoz
Make sure that in your other SSIDs the authentication servers and accounting servers are not enabled globally by accident.
You can check this with the command show wlan id and looking for the output below.
Radius Servers
Authentication................................ Global Servers
Accounting.................................... Global Servers
If this is the case then disable the global authentication servers and accounting servers in your SSID configuration (or select the RADIUS Servers to override).
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide