This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC!
We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.
Hi Team,
Good day!
This would be a generic question regarding a NEAT setup in the customer's environment. So as per the customer's requirement,
they would like to push a Native VLAN to the Trunk port on the Authenticator Switch. This is required as there is a Native VLAN
mismatch between the Supplicant and Authenticator Switch, which doesn't let the traffic through. From what I understood in trying
to set it up, I couldn't find any relevant document/article which said a Native VLAN could be pushed from ISE, but however would
like to confirm on the same. Any inputs or advices on the same would be very helpful.
Thank you!
Regards
Mohammed Nazeeh
Solved! Go to Solution.
Hi Hari,
Thank you for the response.
It was a doc which I never came across. That really did help me out.
Regards
Nazeeh