Passive ID for ISE 3.0

[old roo]

Hi All,

Am trying to setup Passive ID using the Agent in HA setup as per document below.

https://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/216512-configure-evt-based-identity-services-en.html#anc9

Has anyone had any success with this setup. All the troubleshooting offered in the document checks out fine. However not getting any session information in ISE.

The DC's are various versions, however the agents are installed on windows 2019 servers.

Have raised a TAC case as the GUI seems buggy and limited.

[howon · Accepted solution]

Please continue working with TAC on this.

[old roo · Accepted solution]

ok the solution to this was a patch (4) as issues was caused by a bug on the MnT Nodes. This affected the passive ID functionality and licensing, where both would function upto 4 hours after rebooting the nodes, then cease to function again.

[Suparich2016]

Hello, I am trying to do the same, set up the EVT-Based Identity Services Engine Passive ID Agent. Where can I find the system requirements?