RADIUS problem on new ISE 1.4 installation

[StuartR]

HI,

I'm having an issue with a new ise installation. I have 4 3415 nodes with which were all upgraded out the box from 1.3 to 1.4.

I'm testing used a ASA configured for ssl vpn termination. The policy nodes are getting the radius packets, but are they being dropped with no response.

I'm seeing nothing in the operations logs, or any of the reports regarding dropped packets or misconfigurations.

I'm not sure what else I could check before logging a tac case.

Regards

Stuart

[jan.nielsen]

Can you ssh to the psn's, if so, what interface number has the ip address ?

[StuartR]

Hi,

The interfaces were good after the upgrade. I'm guessing I was affected by the bug below even though I was doing an upgrade from a new 1.3 to 1.4. Doing a clean build from the 1.4 iso has fixed the issue.

ISE 1.3p2 upgrade to 1.4 breaks iptables rules - all radius dropped CSCuu43966

[jan.nielsen]

Great info Stuart, will have to watch out for that one, hopefully it'll be fixed soon

[Andre Neethling]

I think I was affected by this bug. I will try a fresh install from the ISO too.

Thanks Stuart