cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Announcements
Choose one of the topics below to view our ISE Resources to help you on your journey with ISE

This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.

348
Views
5
Helpful
3
Replies
Highlighted
Contributor

SF500 and posture suppport

Hi Experts,
Is there any support for Cisco SF500 and Cisco ISE 2.4.
Since I do not see this switch listed in the compatibility matrix here

If it supported, then does it support, redirection, CoA and VLAN change via ISE posture profile.

Any pointer is much appreciated.a

Everyone's tags (3)
2 ACCEPTED SOLUTIONS

Accepted Solutions
Highlighted
VIP Advisor

Re: SF500 and posture suppport

I don’t believe it’s up to ISE to list the support of all potential devices. Check the switch’s Admin/User Guide .

 

If the switch supports RADIUS then you’re half way there. Check if it supports COA (RFC3576). Dynamic VLAN assignment should also be pretty standard. 

 

Even if its RADIUS support does not conform to other Cisco devices, ISE can be configured to support custom attributes and even Custom Device Profiles.  

View solution in original post

Highlighted
Cisco Employee

Re: SF500 and posture suppport


@Arne Bier wrote:

I don’t believe it’s up to ISE to list the support of all potential devices. Check the switch’s Admin/User Guide .

 

If the switch supports RADIUS then you’re half way there. Check if it supports COA (RFC3576). Dynamic VLAN assignment should also be pretty standard. 

 

Even if its RADIUS support does not conform to other Cisco devices, ISE can be configured to support custom attributes and even Custom Device Profiles.  


Correct, Please use Does ISE support my Network Device

View solution in original post

3 REPLIES 3
Highlighted
VIP Advisor

Re: SF500 and posture suppport

I don’t believe it’s up to ISE to list the support of all potential devices. Check the switch’s Admin/User Guide .

 

If the switch supports RADIUS then you’re half way there. Check if it supports COA (RFC3576). Dynamic VLAN assignment should also be pretty standard. 

 

Even if its RADIUS support does not conform to other Cisco devices, ISE can be configured to support custom attributes and even Custom Device Profiles.  

View solution in original post

Highlighted
Cisco Employee

Re: SF500 and posture suppport


@Arne Bier wrote:

I don’t believe it’s up to ISE to list the support of all potential devices. Check the switch’s Admin/User Guide .

 

If the switch supports RADIUS then you’re half way there. Check if it supports COA (RFC3576). Dynamic VLAN assignment should also be pretty standard. 

 

Even if its RADIUS support does not conform to other Cisco devices, ISE can be configured to support custom attributes and even Custom Device Profiles.  


Correct, Please use Does ISE support my Network Device

View solution in original post

Highlighted
Contributor

Re: SF500 and posture suppport

Yes, understood. Integrating any other switch than the one listed in the matrix would require some more testing efforts from our end.
Just make sure that those NAD support either Radius CoA or SNMP CoA to start with.