shutdown ise

[kp-tkr2014]

Hi,

If  I want to power off the ise appliance ,

Is it ok just run the command "application stop ise "

then manually power off the device ?

Thanks 

[Jatin Katyal]

Imp > Before you shutdown the ISE node, take a configuration and operational backup.

The correct way to shut down an ISE node is
1. Application stop ise
2. Halt

halt :Disables or shuts down the Cisco ISE server.
https://www.cisco.com/c/en/us/td/docs/security/ise/2-3/cli_guide/b_ise_CLIReferenceGuide_23/b_ise_CLIReferenceGuide_23_chapter_011.html

[kp-tkr2014]

Hi,

Configurational and operational backup always stuck at 20% .

even after upgraded multiple times .

Tried only configuration  ,same problem . 

By the way it is secondary node . 

Thanks 

[ajc]

Configuration and Operational Backup are ONLY created from Primary PAN

[sonalivapilkar2197]

Could you also share the command to power on the application?

[Marcelo Morais]

Hi @sonalivapilkar2197 ,

 to start ISE Application, use the:

ise/admin# application start ise

 to check the ISE Application status, use the

ise/admin# show application status ise

For example:

ise/admin# show application status ise
ISE PROCESS NAME STATE PROCESS ID 
--------------------------------------------------------------------
...
Application Server running 16566
...

Hope this helps !!!

[sonalivapilkar2197]

Hi @Marcelo Morais 

Thanks, it helped. Anyhow, in my environment, when the VM was powered on the services were up and running again without any input from my side. Hoping this would help someone else!