SSH Access to the ACS 5.1

[sidcracker]

Is there any requirement of installing any certificates on the ACS if authentication is performed from a SSH client.

I am getting the below messages when I access from a SSH client

1. Bind i/f

2. Pick method list default

and then it just fails to authenticate, This works well with telnet.

Thanks

[sidcracker]

Hi

These routers have a primary and secondary path. The ACS was Always asking for the secondary path ip address. I had to change the ip address on the AAA network device in ACS and it worked fine.

Thanks

Sent from my iPhone

[andamani]

Hi,

were there VRF's configured.

A command exists in the IOS to direct the authentication request to a interface.

ip tacacs source-interface subinterface-name

You can try the above command and let us know if that works instead of changing the IP Address of the ACS server.

http://www.cisco.com/en/US/docs/ios/12_2/security/command/reference/srftacs.html#wp1017795

Regards,

Anisha

- do rate helpful posts.

[Jatin Katyal]

I think we aready discusse ths in our previous discusion and I tod you that this could be a source//destinalion ip issue.

https://supportforums.cisco.com/message/3282964#3282964

Rgds, Jatin

Do rate helpful posts~