08-18-2015 08:47 AM - edited 03-10-2019 10:59 PM
Has anyone downloaded and installed the new ACS Patch?
On installation I get the following error: "% Internal error during command execution"
I've tried downloading a few times with same result. Opened TAC - waiting.
Doug.
Solved! Go to Solution.
08-18-2015 11:33 PM
Hi Doug,
Base Patch ACS57BasePatch.tar.gz has to be applied before applying 5.7 p1. Have you applied it?
08-18-2015 11:58 AM
Hi Doug,
Can you share the procedure you followed?
Regards,
Kanwal
Note: Please mark answers if they are helpful.
08-18-2015 11:33 PM
Hi Doug,
Base Patch ACS57BasePatch.tar.gz has to be applied before applying 5.7 p1. Have you applied it?
08-19-2015 05:59 AM
Perfect, Thanks. re-read the release notes but I had skipped over that. Didn't see any mention of a patch install problem in the Resolved Issues so I went directly to the cumulative patch.
Cheers !
07-07-2016 01:14 PM
Hello;
I am attempting to install the Base Patch ACS57BasePatch.tar.gz and still get the "% Internal error during command execution". What am I missing here? Appreciate help from anyone at this time.
07-07-2016 05:52 PM
Hi,
Kindly install the patch using the below command instead of "acs patch install" command.
ACS/admin# patch install ACS57BasePatch.tar.gz <name of repository
07-08-2016 07:05 AM
Hi again;
Thank you for your reply.
I attempted to install the ACS 57 Base Patch file as instructed and still getting the same error "% Internal error during command execution". On CLI, from the "Show repository <name of repository>" command, I can see the repository and the installation files, but it does not show the ACS57BasePatch.tar.gz file (even though it is present in the repository folder). I welcome any or all suggestions to help resolve my issue. Thanks again.
07-08-2016 07:23 AM
Hi Nhkelley,
Please check ,have you copied the ACS57BasePatch.tar.gz file to configured directory in ACS .
I am suspecting you may be copied that file to some other directory in the repository .
Please try to connect the repository and check the file in directory .
We will get above mentioned exception ,if there is no file in the repository .
Please check once again file in the repository directory and install it same command .
Could you please let us know the results .
Thanks
VenkataKrishna
Please rate helpful posts and mark correct answers.
07-08-2016 07:39 AM
You are correct, that exactly was my problem (files copied to some other directory in the repository). Thank you very much!!
07-08-2016 08:17 AM
Hi Nhkelley,
Please rate helpful posts and mark correct answers.
Thanks
VenkataKrishna
07-08-2016 10:30 AM
5 star vote submitted. Correct answers. Thanks!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: