Using SSH in CiscoWorks to Manage PIX

[steve.carlson]

I am trying to get our CiscoWorks to manage a PIX 520 firewall running ver 6.3.3. It seems to get SNMP information but getting and managing the configs has been a problem. When I look in the PIX log I see this message: INFO %PIX-6-315011: SSH session from 10.80.134.21 on interface inside for user "manage" disconnected by SSH server, reason: "packet CRC check failed" (0x02). The session gets set up but then it gets dropped.

I can't find any information on pix message 315011. I can ssh into the pix using putty just fine. Can Ciscoworks even do this?

Thanks,

Steve

[ywadhavk]

Hi steve,

Not sure what address is 10.80.134.21. Is it that of the CW server?

If so, can you run the below command from the CW server and see what happens?

plink -ssh userid@x.x.x.x

where userid id the id that you use to login to the PIX ip address of x.x.x.x

thanks

yatin

[egerritsen]

Steve,

Maybe you already know, but the pix only understands SSH version 1. Putty can also use SSH version 1. I don´t know if you can use SSH-1 with Cisco works .

Edwin Gerritsen

Dhs Informatisering

egerritsen@dhs.nl