02-07-2013 05:17 PM
I have a 6509 on my network and also have LMS4.1 for management. My 6509 is listed in my lms as a device. The config is in LMS. But I am not getting any syslog messages in LMS for my 6509. I have logging turned on and I have my LMS server listed in the config using the logging IP address command. What could be missing that would prevent the syslog messages from showing up in LMS. I have other devices that send syslog messages fine.
Sent from Cisco Technical Support iPhone App
Solved! Go to Solution.
02-07-2013 05:33 PM
Hi Eric,
Hope you have set following.
logging on
logging facility syslog
logging trap <
logging source-interface <
logging <
If still this is not working could you share the output of "show logging"
Regards
Najaf
Please rate when applicable or helpful !!!
02-07-2013 05:33 PM
Hi Eric,
Hope you have set following.
logging on
logging facility syslog
logging trap <
logging source-interface <
logging <
If still this is not working could you share the output of "show logging"
Regards
Najaf
Please rate when applicable or helpful !!!
02-07-2013 06:02 PM
You nailed it. It was the source-interface command that did the trick.
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide