Hi ,
I am having issue with my NTP sync.
I have configured the NTP as below. The route to NTP server is on int VLAN 221 which is having ACL out. But inside the ACL , i already allowed for the NTP traffic. But my show ntp status still unsync to NTP server.
Anyone can advise if any woring in config. Is the locally generated traffic applicable to ACL?
NOTE: I got another switch connected another interface( int VLAN 150) on this Switch1. It is syned with NTP server.
Switch1 #sh run | i ntp server
ntp server y.y.y.y
ntp server x.x.x.x prefer
Switch1#sh ip route x.x.x.x
Routing entry for x.x.x.0/28
* directly connected, via Vlan221
Route metric is 0, traffic share count is 1
interface Vlan221
ip address x.x.x.w 255.255.255.240
ip access-group VLAN_221_out out
Extended IP access list VLAN_221_out
10 permit tcp any any established (5 matches)
20 permit udp any host x.x.x.x eq ntp
30 permit udp any host y.y.y.y eq ntp
Thanks
WPA