cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

ACS 5.5

prashantrecon
Beginner
Beginner

Hi All,

Facing issue mentioned below

created two NDG with switches and Coreswitches.

Than created two access rule

Rule 1 with NDG as Switches 

Rule 2 with NDG as coreswitches.


Acs is intergarted with AD.


Devices under NDG type switches works absoutely fine.

Devices under NDG type coreswitch gives command authorization failed (username get autheticated)


When the devices are moved to NDG switches  everything works fine.

 

2 REPLIES 2

AFROJ AHMAD
Cisco Employee
Cisco Employee

Hi ,

 

check the privileges level set for the group "coreswitches" , it should be level 15.

 

Thanks-

Afroz

***Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****

It is already 15

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: