cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
400
Views
0
Helpful
0
Replies

ANA/prime "BGP process down" no mention of the client VRF

Hey there!

Im having some alarms:"BGP process down" on Cisco ANA ver: 3.7.

but why it doesn't show the client VRF like the syslog warning "%BGP-5-ADJCHANGE: neighbor 10.x.x.246 vpn vrf client Down BGP Notification sent"?

Is this a normal behaviour?

From the manual i have this:

     1) BGP Process Down

Description: "Issued when the BGP process/service is down after it was up. The BGP component in the VNE identifies this change,updates its state, and issues the alarm."

Correlation  "Due to the nature of this alarm, it cannot be correlated to other alarms, thus this alarm does not try to run any correlation process."

     2) BGP-5-ADJCHANGE

On the syslogs im having "%BGP-5-ADJCHANGE: neighbor 10.x.x.246 vpn vrf client Down BGP Notification sent", but the ANA logs has  no mention of the client VRF.

Description: "handle BGP 5 syslog"

        PS: the only thing that im aware vrf related is the mention that the alarm BGP-5-ADJCHANGE-vrf should be seen before the pattern "%BGP-5-ADJCHANGE"

     3)BGP-5-ADJCHANGE-vrf

Description: ""handle BGP 5 syslog from vrf. make sure it is before the "BGP-5-ADJCHANGE" pattern""

So my question is that if the "BGP process down" alarm shouldn't have the client VRF included in its alarm? is this  the expected output?

RF

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards