Is there a way to decouple the database from PI ? that way our deployment would be way more scalable.
Currently there is no way to decouple database from PI. I haven't seen any plans to do so yet.
Also it would be great to know if PI supports two or more NICs, just like Iris de Boer asked above.
Please see the thread above where I have replied to this.
I installed Cisco Prime Infrastructure 2.1 for 60-days evaluation and i added routers, switches and APs. I configured SNMP community and telnet credentials. I can see clients on Dashboard, but when i go to reports and generate them for last hour, it displays "None Detected".
Did i miss something?
Good observation Moustafa,
I did run a client count report for last one hour and I was able to generate the report. I need to know more specifics like What report are you running? what type of clients are you selecting? Do you see those clients associated or connected in the "clients and users" dashboard? Please advise, and I can look into this even after this event ends..
Dear Tejas Shah,
Can you provide good guide how to add cisco routers,switchs to PU 1.2
I have problem: i added switch, but i just see its name on page Operate/Device Work center and it shows that Managed. But all dashboards are empty. All documentations are for old versions.
Please, provide normal step by step guide for configuration Prime Infrastructure.
There is a very nice deployment guide for PI 1.2 with step by step procedure posted here:
Cisco Prime Infrastructure supports all versions of SNMP: v1, v2c, and v3 (noAuthNoPriv, authNoPriv, authPriv).
That is correct Marvin.. Just a side note. We had some issues initially with PI 1.1 and SNMPv3, but we had successfully used PI 1.2.1 with SNMPv3 at Ciscolive UK couple weeks back, and it worked great.
I'd like to know if there are any known interoperability issues when attempting to manage access switches/stacks as every 3750x running lanbase and 2960 comes up as "Managed with Warnings". Our cores running IPServices are managed with no issues. It says to see the inventory.log file, but the erro thrown is nonsensical.
2012-12-12 10:39:44,143 [ICE Service[ 1]Thread: 6] ERROR inventory -
I've This was an issue from the first deployment of PI 1.2 and continues in version 1.2.1.012.