Hi I'm trying to monitor the different CPUs on an ASR 1001-x but so far i can only seem to monitor the RP. I have followed the document on cisco asr oids
It indicates the following,
ASR1K#show platform software status control-processor brief | section Load
Slot Status 1-Min 5-Min 15-Min
RP0 Healthy 0.75 0.47 0.41
ESP0 Healthy 0.00 0.00 0.00
SIP0 Healthy 0.00 0.00 0.00
It corresponds to:
220.127.116.11.18.104.22.168.22.214.171.124.1.24.2 = Gauge32: 75 -- 1 min RP0
126.96.36.199.188.8.131.52.184.108.40.206.1.24.3 = Gauge32: 0 -- 1 min ESP0
220.127.116.11.18.104.22.168.22.214.171.124.1.24.4 = Gauge32: 0 -- 1 min SIP0
126.96.36.199.188.8.131.52.184.108.40.206.1.25.2 = Gauge32: 47 -- 5 min RP0
220.127.116.11.18.104.22.168.22.214.171.124.1.25.3 = Gauge32: 0 -- 5 min ESP0
126.96.36.199.188.8.131.52.184.108.40.206.1.25.4 = Gauge32: 0 -- 5 min SIP0
220.127.116.11.18.104.22.168.22.214.171.124.1.26.2 = Gauge32: 41 -- 15 min RP0
126.96.36.199.188.8.131.52.184.108.40.206.1.26.3 = Gauge32: 0 -- 15 min ESP0
220.127.116.11.18.104.22.168.22.214.171.124.1.26.4 = Gauge32: 0 -- 15 min SIP0
However the above command on the ASR 1001-x does show the ESP. Also from the OIDs listed 126.96.36.199.188.8.131.52.184.108.40.206.1.24 25 and 26 work and display the 1 min 5 min and 15 min RP load.
Does anyone know the OIDs for the ESP and QFP ?
you are using the Cisco process MIB
you can find the MIB definition here
The MIB is not updated since 2011.
it is declared to be supported and verified on ASR 1000 at the following link
Hope to help
Guiseppe, you are always busy replying lol.
To be honest with you i dont even know what do do with that file, do I uploaded to the router, if so were do i put it, or is that just for reference ?
I was actually able to find the QFP load its OID ..220.127.116.11.18.104.22.168.722.214.171.124.1.14.9026 RP is OID .126.96.36.199.188.8.131.52.184.108.40.206.1.24/25/26 now i just need ESP/FECP
>> or is that just for reference ?
Just for reference, the router has already the MIB "on board".
The OID you have found for QFP is in CISCO-ENTITY-QFP-MIB.
>> Guiseppe, you are always busy replying lol.
I will go to sleep now I promise :)
Hope to help