ASR-920-12CZ USB MEM question?

KellanCarson · ‎05-03-2021

I am working with ASR-920-12CZ's and am in the process of updating the IOS in dozens of 920's. Recently I have ran into a batch where the USB MEM port is not recognizing my memory stick and have to resort to updating the IOS over tftp. That wouldn't be a problem but I have so many to get through and it's a much slower process.

I have searched for a while to find out how/if I can shut, no shut the USB MEM port as it acts as though it is shut down. Does anyone know what I can do to troubleshoot the status of the USB MEM port and get it activated when I run into this again?

Thanks in advance

[url=https://omegle.onl/][color=#333333]omegle[/color][/url] [url=https://xender.vip/][color=#333333]xender[/color][/url]

marce1000 · ‎05-03-2021

- Check , if you can observe anything in the logs when the USB is inserted, also make sure the USB is FAT-formatted, if possible try an USB from another vendor too.

M.

-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !