Bandwidth utilization on topology diagram of LMS 4.2

[Pandian G K]

Hi,

  I am running LMS 4.2 , using that i am monitering some switches . I am using topology services also  . In that i am getting veiw of all connected devices with links. But bandwidth utilization is for those links are not showning in topology veiw .

Is there any settings to be done in LMS 4.2.2 or any configuration changes to done on my switches ??  to find the traffic flow  bandwidth utiliztion.

thanks ,

pandian .

[rgomes]

Hi

You have to enable RMON to measure bandwidth utilization.

Take a look on the Monitoring and Troubleshooting With Cisco Prime LAN Management Solution 4.2 guide.

Begining on the page 7-43 you can find the procedure.

Hope you can set it